AB Inflatable Boat Handle, Molded EPDM Rubber, for Hypalon Inflatable Boats, Available in Gray, White or Black

Description

Inflatable boat molded glue-on grab handle used on most AB Inflatables and other brands of Hypalon inflatable boats.

• Molded EPDM rubber which is the only type of material that sticks to Hyalon/CSM fabric.
• 11-13/16″ long x 4-3/4″ wide.
• AB Part #AB85026-0010.
• Order 2-part Hypalon glue and Toluol solvent separately (See related products below).
• Available in Gray, White or Black.

Handle Installation Instructions:

1. If removing old handle, use Toluol and hair dryer to remove.
2. Also, remove old adhesive with Toluol.
3. Sand area of boat where handle will be installed. Clean with Toluol again.
4. Apply 3 thin layers of Hypalon glue, allowing each layer to become tacky (approx. 20 minutes).
5. Stick Handle to boat and allow 24 hours to dry.