Inflatable Boat Seat Holder, Pair, 11-3/4″ x 5″

Description

Glue down seat holder for all PVC inflatable boats. PVC adhesive is required for the this installation. See related products below. Simply install these seat holders on your boat and cut a piece of marine plywood according to the beam of your boat.

Instructions:

Sand the bottom of the seat holders rigorously and clean with MEK

Clean the installation area of the boat with MEK

Apply 3 thin layers of PVC glue allowing each application to dry for 20 minutes

Stick the seat holders down and allow to dry for 24 hours in a low humidity environment